Filter
Top Products
Configuring the printer
3-4
S for the CI - 4080
PRINT OUT VERSION 202xxxxx
INTERFACE ADJUSTMENT
BUFFER 8 KBYTE AGC POSITION 24
WORD LENGTH 8 BIT PLATEN GAP 0
I/F TYPE SHARED PAPER-IN ADJ. 0 *)
BAUD-RATE 9600 BPS CUT. V-POS LO. 0
PARITY BIT EVEN CUT. V-POS UP. 0
PROTOCOL DTR UNI-DIRECT.CMD YES
TRACT. FF-MODE IGNORE FF
MENU ACCESS ALL FUNCTIONS
CURRENT SETTINGS MACRO 1* MACRO 2 MACRO 3 MACRO 4
FONT DATA DATA DATA DATA DATA
PRINT QUALITY LQ LQ LQ LQ LQ
GRAPHICS QUAL. STANDARD STANDARD STANDARD STANDARD STANDARD
SUB/SUPER FONT YES NO YES YES YES
PITCH 10 CPI 10 CPI 10 CPI 10 CPI 10 CPI
LINE 6 LPI 6 LPI 6 LPI 6 LPI 6 LPI
PAGE LENGTH 72 LINES 72 LINES 72 LINES 72 LINES 72 LINES
TRACT.L. V-POS 0 0 0 0 0
TRACT.U. V-POS 0 0 0 0 0
LEFT MARGIN 1 COLUMNS 1 COLUMNS 1 COLUMNS 1 COLUMNS 1 COLUMNS
RIGHT MARGIN 136 COLUMNS 136 COLUMNS 136 COLUMNS 136 COLUMNS 136 COLUMNS
TOP MARGIN 1 LINES 1 LINES 1 LINES 1 LINES 1 LINES
BOTTOM MARGIN 1 LINES 1 LINES 1 LINES 1 LINES 1 LINES
PERF. SKIP YES YES YES YES YES
PAPER SOURCE TRACTOR LOWER TRACTOR LOWER TRACTOR LOWER TRACTOR LOWER TRACTOR LOWER
PATH BATCH BATCH BATCH BATCH BATCH
STACK.CAPACITY - - - - -
BATCH CAPACITY - - - - -
EMULATION EPSON LQ EPSON LQ IBM PROPR. IBM PROPR. AGM EPSON LQ
CHARACTER SET EPSON EXT. GCT EPSON EXT. GCT IBM SET 2 IBM SET 2 EPSON EXT. GCT
3: GERMANY 3: GERMANY 1: U.S.A. 1: U.S.A. 1: U.S.A.
LINE MODE LF=LF, CR=CR LF=LF, CR=CR LF=LF, CR=CR LF=LF, CR=CR LF=LF, CR=CR
$$-COMMAND NO NO NO NO NO
TEAR-OFF / CUT NO NO NO NO NO
Note: An asterisk (’) after MACRO 1 indicates the actual macro.
*) This value is dependent on factory setting!
All this standard settings of the firmware will be restored with the menu
function RECALL FACTORY.