Filter
Top Products
Configuring the printer
3-13
S Paper Exit (only for CI - 4080)
It is possible to choose between BATCH (to leave the printer at the rear) and
STACKER (at the top) via the point PATH.
If BATCH is selected, the paper keeps its continuous form and leaves the
printer at the rear. The cutter is not activated by default. If print jobs need to
be separated, the cutter must be activated.
If STACKER is selected the fanfold paper automatically leaves the printer as
cut sheets which are collected face down in the stacker at the top. The paper
is cut along the perforation as long as no other form length has been defined.
The form length can be determined in the menu or by the application. Printing
briefly stops when the paper arrives at the cut station. The paper gets cut and
is transported to the stacker. Afterwards, printing resumes.
Note: If, for some reason, it is not desired to print exactly on the perforation it is
very important to cut below the perforation of the printed page. If the
paper is cut above the perforation the remaining paper can easily bend
and cause a paper jam. Do not cut through a label as the blad would get
dirty by the glue.
S STACK.CAPACITY (capacity at the top)
(only for the CI - 4080)
S BATCH CAPACITY (capacity of the option at Cut Sheet Tray at the rear)
(only for the CI - 4080)
To control the capacity of the Stacker or the Cut Sheet Tray use these two
functions. Capacity can be defined in steps of 20 single sheets.
S STACK.CAPACITY in the range from 20 to 200 and
S BATCH CAPACITY from 20 to 600 sheets. (single sheet paper, see
chapter 6 Technical Data, paper specification )
Change of Paper Exit (only for the CI - 4080)
When switching from one paper exit to the other, paper in the printer moves
automatically to the cut station where it is cut at the perforation below the last
printed page.