Filter
Top Products
Configuring the printer
3-10
+/- 1 = +/- / " = +/- 0,42 mm
1
60
+/- 2 = +/- / " = +/- 0,85 mm
2
60
+/- 3 = +/- / " = +/- 1,27 mm
3
60
+/- 4 = +/- / " = +/- 1,69 mm
4
60
+/- 5 = +/- / " = +/- 2,12 mm
5
60
+/- 6 = +/- / " = +/- 2,54 mm
6
60
+/- 7 = +/- / " = +/- 2,96 mm
7
60
+/- 8 = +/- / " = +/- 3,39 mm
8
60
+/- 9 = +/- / " = +/- 3,81 mm
9
60
+/- 10 = +/- / " = +/- 4,23 mm
10
60
+/- 11 = +/- / " = +/- 4,66 mm
11
60
+/- 12 = +/- / " = +/- 5,08 mm
12
60
+/- 13 = +/- / " = +/- 5,50 mm
13
60
+/- 14 = +/- / " = +/- 5,93 mm
14
60
+/- 15 = +/- / " = +/- 6,35 mm
15
60
+ 16 = + / " = + 6,77 mm
16
60
S Vertical Positioning Adjustment (VERT.POS.ADJ.)
This can be set differently for each macro to exactly position the printout in
relation to the top edge of the form in use. It is meant to be a corrective
parameter to meet variations in paper size and pre-printed material. Using this
function, the TOP MARGIN and BOTTOM MARGIN setting are taken into
account as well.
This parameter covers a range of - / to + / of an inch, where "-" is up
15 240
60 60
the page and "+" is further down the page.
The following table shows some values in inch and millimetres.
Attention: The set up of VERT.POS.ADJ. will become effective at the next page
of the form. Therefore, it is recommended to perform
VERT.POS.ADJ. set up as long as the paper is in the park position
and before starting the print job.
S The left margin is set in / " steps, depending on the actual selection. The
1
10
first left margin position is / " from the left edge of the paper which means
1
20
that the letter H in regular "Data" font would be positioned / " from the left
1
20
edge of the paper. The left margin can be set to a maximum of / ".
15
10