Filter
Top Products
Configuring the printer
3-16
The setting TEAR - OFF 1 S causes the paper to move to the tear off position
when the print job has been completed by a form feed command and no new
print job has been received within one second. If the paper is not torn off and
new printing data are received the paper moves back into the printer to allow
the following page to be printed.
The setting CUT 10 S (CI - 4080) causes the form to be cut if no further
printing data have been received within a print job for a period of 10 seconds.
After cutting, the paper moves immediately into the top of form position of the
next page. This setting supports applications lacking a programmed form feed
after completion of a print job.
The setting CUT 1 S (CI - 4080) causes the form to be cut if, after a form
feed command, no further printing data have been received within a print job
for a period of 1 second. After cutting, the paper moves immediately into the
top of form position of the next page.
The setting CUT 1 S NO FF (CI - 4080) has the same function as CUT 1 S
but is independent of receiving of a form feed command.
By the function CUT MODE ON and PATH = BATCH in PAPER EXIT the
CI - 4080 will cut continuous forms into single sheets and feed them to the
rear. Use the optional Cut Sheet Tray to collect the sheets. The application
has to control page length. The page length must be at least three inch,
otherwise the printer is unable to through out the sheet.