Filter
Top Products
Plugging In the Printer
1. Make sure the printer is turned off. The printer is off when
the
N
side of the power switch is pressed.
2. Check the label on the back of the printer to make sure its
voltage matches that of your electrical outlet. Also make
sure the plug on your printer’s power cord matches your
electrical outlet.
c
Caution:
It is not possible to change the printer’s voltage. If the
rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the
power cord.
3. If the power cord is not attached to the printer, plug the
appropriate end into the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
1
R
Maple Rev.D
A5 size Chapter 1
97/06/17 pass 0
Setting Up the Printer
1-9