Filter
Top Products
Installing EPSON Status Monitor 2
After you have installed the printer driver for Windows 95,
follow the steps below to install the EPSON Status Monitor 2
utility program.
Note:
Install the printer driver before installing the Status Monitor utility.
If you already installed the Status Monitor before the driver, install
the Status Monitor again after completing the driver installation.
1. Insert the Disk 1 of the EPSON Status Monitor 2 software in a
floppy disk drive.
2. Click
START
and
Run
.
3. Type
A:\SETUP
(if you inserted the driver disk in a drive
other than drive A, substitute the appropriate letter) and
click
OK
.
4. Follow the on-screen instructions, then click
FINISH
to
complete the installation procedure.
See Chapter 5, “Using EPSON Status Monitor 2,” for
instructions on how to use the Status Monitor.
L
Maple Rev.D
A5 size Chapter 2
06/17/97 pass 0
2-8
Setting Up Your Software