Filter
Top Products
49
When You Suspect a Problem
Only part of the image is displayed (large/small)
• Change the resolution for the notebook
computer or computer with an LCD screen.
Change the resolution so that the image is displayed in the whole of the
projection area, or set the image signal to external output only. See “
Selecting
the Input Source” on page 28.
• Is the aspect ratio set correctly? Press the [Aspect] button to set the aspect ratio to 4:3. See “
Projecting in
widescreen (changing aspect ratio)” on page 31.
• Has the computer been set for dual display? If dual display has been activated in the Display Properties of the connected
computer’s Control Panel, the projector will only display about half of the image
on the computer screen. To display the whole of the image on the computer
screen, turn off the dual display setting. Refer to the video driver manual for the
computer’s monitor for further details.
• Has the correct resolution been selected? Set the computer so that the signals that are output are compatible with this
projector. Please refer to your computer’s documentation for further details. See
“
Supported Display Resolutions” on page 64.
• Has the position been adjusted correctly? Use the “Setting” → “Screen” → “Position” configuration menu to correctly
adjust the display position. See “
Setting menu” on page 39.
• Is the E-Zoom function being used to enlarge
the image?
Press the [Esc] button on the remote control to cancel E-Zoom.
See “
E-Zoom” on page 31.