Filter
Top Products
How to Use This Appendix
The instructions in this appendix describe how to install and
remove optional Epson diskette and hard disk drives. All
drives sold by Epson for the Equity 386SX/16 PLUS are
qualified and recommended for use in this system. Your drive
may look a bit different from the one illustrated in this
appendix, but you install it the same way.
If you are installing or removing a non-Epson drive, some of
the steps in this appendix may not apply to your drive; see
the documentation that came with it for more information.
Each section describes a part of the process you may need to
perform. Here are the guidelines:
Ll
cl
CL
Before you begin any of the procedures described in this
appendix, follow the steps in Chapter 5 to remove the
computer’s cover.
If you are removing your only hard disk drive, see “Removing
a Hard Disk from the Vertical Position” on page B-24.
If you are installing a hard disk drive or removing one
and leaving another in the computer, follow the steps
under “Setting the Hard Disk Drive Jumpers” on page B-4
first.
If you are installing or removing a diskette drive and
there is a hard disk drive installed in the vertical
mounting position, see “Removing a Hard Disk from the
Vertical Position” on page B-24.
If you are installing or removing a diskette drive and
there is no hard disk drive installed in the vertical
mounting position, see “Installing or Removing a Disk
Drive in the Horizontal Position” on page B-27.
Additional instructions in each section tell you which steps
to perform next.
Installing and Removing Disk Drives
B-3