Filter
Top Products
Table D-1.
DIP
switch group 1
Switch
Action
number
Function
when ON
1-1
Select condensed or normal
Condensed
characters
1-2
Select slashed or unslashed zero
0
1-3
Select character table*
Graphics
1-4
Select printer commands
IBM printer
emulation
mode
1-5
Select print quality
NLQ
1-6
Select international character set
1-7
I
I
See Table D-3
I
1-8
‘In IBM printer emulation mode, a CR IS added to an LF or ESC J if this switch IS OFF
Table D-2.
DIP
switch
group
2
Switch
Action
Action
number Function
when ON when OFF
2-1
Select page length
12 inch 11 inch
2-2
Select automatic sheet feeder
Selected Not selected
mode
2-3
Skip-over-perforation
1
inch
None
2-4
Add line feed after carriage return CR + LF
CR only
Note: The factory setting for all switches except 1-6, 1-7. and 1-8 iS OFF
International Character Sets
Thirteen international character sets are available in Epson mode.
Eight of these are selected by DIP switches 1-6 to 1-8 and the remaining
five (Japan, Norway, Denmark II, Spain II and Latin America) can be
selected with the ESC R command, which is described in the
Command Summary. For the characters available in each character set,
see Appendix B.
In IBM printer emulation mode, you can select only two character
sets; the standard character set (Table 1) and the international
character set (Table 2). You can see the differences by looking at the
IBM character tables in Appendix B. There is also a command to let
you print any of the characters in the international character set and
several additional characters. Together these form the symbol set. The
Defaults and DIP Switches
D-3