Filter
Top Products
26 Paper Handling
Adjusting the tear-off position
If your paper’s perforation is not aligned with the tear-off edge, you can
use the Micro Adjust feature to move the perforation to the tear-off
position.
Follow these steps to adjust the tear-off position:
1. Make sure the Tear Off (Font) lights are flashing (the paper is at the
current tear-off position). You may need to press the Tear Off (Font)
button to advance the paper to the tear-off position.
2. Open the printer cover.
3. Hold down the Pause button for about three seconds. The printer
beeps and the Pause light begins to flash as the printer enters
Micro Adjust mode.
4. Press the LF/FF D button to feed the paper backward, or press the
Load/Eject U button to feed the paper forward, until the paper
perforation is aligned with the tear-off edge on the paper tension
unit.
Note:
The printer has a minimum and a maximum tear-off position. If you try to
adjust the tear-off position beyond these limits, the printer beeps and stops
moving the paper.
5. After you set the tear-off position, press the Pause button to exit
Micro Adjust mode.
6. Tear off the printed pages.
Tear-off edge