Filter
Top Products
Troubleshooting
6 Troubleshooting
This chapter describes how to solve a number of issues that could occur
during installation, configuration, and use of the Ericsson W25. More
information is available at www.ericsson.com/fwt.
Before you try any of the methods described in this chapter, make sure that
the connected cables are securely inserted and that the Power indicator on
the Ericsson W25 is green.
If none of the suggested methods solve your problem, you are
recommended to:
1. Restart the Ericsson W25 (see section 6.1).
2. Reset the Ericsson W25 to factory default configuration (see section
6.2).
3. Contact your service provider.
6.1 Restart the Ericsson W25
To restart the Ericsson W25, click Restart on the System web page.
If you cannot access the Ericsson W25 web pages, remove the power
cable to disconnect the Ericsson W25 from power and wait a moment
before reconnecting the cable.
6.2 Reset the Ericsson W25 to Factory Default Settings
The factory default configuration contains the original settings of your
Ericsson W25. When you install your Ericsson W25 and access the web
pages for the first time, the unit has a factory default configuration.
To reset the configuration to factory default settings, click the Reset button
in the “FACTORY RESET” section on the System web page.
If you cannot access the Ericsson W25 web pages, the following procedure
resets all configurable values back to factory default settings:
1. Press the Reset button with the tip of a pen. The Power LED starts
blinking.
72 5/1551-CRH 102 167 Uen Rev E 2008-02-15