Filter
Top Products
Troubleshooting
2. Wait until the Power LED stops blinking which indicates that the reset
is finished.
Note: A reset to factory default configuration cannot be undone. If you
reset the Ericsson W25 to default configuration, all your previous
configuration changes are replaced. If you have previously
changed the user name and password, the User Login page will
be displayed. You have to login to the web pages with the default
user name and password (user in both fields).
6.3 LAN Connections
Table 23
Indication/Symptom What to do
Check the network cable and make
sure that there is a physical
connection between the PC and the
Ericsson W25 and that at least one
of the corresponding LAN
connector indicators is lit. If not,
make sure that the cable is properly
connected or try with another
Ethernet cable.
Cannot access the local network
from a PC that is connected to one
of the LAN ports on the Ericsson
W25, or to an Ethernet switch or
hub that is connected to the
Ericsson W25
Check that the PC is configured to
obtain IP address automatically
using DHCP. If not, change the PC
TCP/IP settings. For instructions,
see section
5.1.1 – Obtaining IP
Settings Automatically or refer to
the manual of your operating
system.
Cannot access the Ericsson W25
internal web pages.
Make sure you are using the
correct Ericsson W25 LAN IP
address. If the LAN IP address has
been changed and you do not know
the current IP address, use the
Reset button to reset the Ericsson
W25 to factory default configuration
(see section
6.2). This will set the
IP address to 192.168.1.1 and the
web page address to
http://192.168.1.1.
5/1551-CRH 102 167 Uen Rev E 2008-02-15
73