Filter
Top Products
Euphonix SH612 Studio Hub User Guide Menu Reference and Technical Specifications
42
Recall Setup
Recalls all parameters from one of 20 locations.
Control Port
This must be set correctly to control the SH612 from the R-1 recorder or System 5 con-
sole. The SH612 can be controlled from System 5 from the RS-422 Control port (serial
9-pin connector) or from the R-1 from the IEEE-1394 port. The unit may appear to be
disabled if the control port selected here does not match the connected port.
Varispeed Display
Shows the extent to which playback speed is altered.
Percent: -12.5% to + 12.5%
Semitones: -2.32 to + 2.40 semitones
5.1.7 Transport
Used with the R-1, the Transport menu converts the SH612 front panel menu controls
into Transport controls. This allows the SH612 to send Machine Control commands to
other devices. This feature is not implemented for use with System 5.
The R-1 must be set to receive Machine Control commands from the SH612 and Ma-
chine Control must be turned on. Two menus provide different controls.
The first menu has:
• Stop: Menu marked by a square; controlled by the Info button
• Forward Play: Menu marked by a single right arrow; controlled by the button
with a single, right arrow
• Reverse Play: Menu marked by a single left arrow; controlled by the button
with a single, left arrow
The second menu has:
• Stop: Menu marked by a square; controlled by the Info button
• Forward Shuttle: Menu marked by a double, right arrow; controlled by the
button with a single, right arrow
• Reverse Shuttle: Menu marked by a double, left arrow; controlled by the but-
ton with a single, left arrow
In the top of each menu the time and play/ stop /shuttle status is shown.