Filter
Top Products
#+"
"
Hint§
The following parameters are shown on the VLAN-Stacking Table Setting:
■ Tag Protocol ID - Tag Protocol Identifier specifies the Ether type of incoming packets on a tunnel port. (Range:
0x0600~0xFFFF hexadecimal, Default: 0x88a8)
■ PVID - The stacking VLAN Port VLAN Identifier. The PVID determines the stacking VLAN tag for
single-tagged packets forwarded to an enabled S-VLAN port.
■ Provider Network Port - Set the S-VLAN membership mode for the selected interface. This mode is used to
segregate and preserve customer VLAN IDs for traffic crossing the service provider network.(Default: Disable)
■ Enable - Indicate a port linked to a service provider (an 802.1Q Tunnel port).
■ Disable - Indicate a port linked to a customer.