Filter
Top Products
%$"
"
Management Access Filter
To create up to eight IP addresses or IP address groups that are allowed access to the switch through the Web
browser.
Web Smart switch interface
1. Click Configuration, Management Access Filter.
2. Enter an IP address
3. Specify a netmask to define a single IP address, or an address range.
4. Select the table entry to activate the filter.
5. Click Apply.
Figure 31: Management Access Filter
Hint§
The following parameters are shown on the LLDP Neighbors page.
■IP Address - An IP address specifies a range, that is allowed management access to the switch.
■IP Netmask - A mask that specifies a single IP address, or a range of IP addresses. (Default: 255.255.255.255
for a single IP address)