Extron electronic 3200 Series Switch User Manual


 
Appendix A • Reference Information
Extron • Matrix 3200/6400 Series • User’s Manual
Matrix 3200/6400 Series Part Numbers
Part Numbers for Matrix 3200/6400 switchers use the following format:
60-25x-iofr
where: x = 0 = Matrix 6400 Wideband
x = 1 = Matrix 3200 Wideband
x = 2 = Matrix 6400 Video
x = 3 = Matrix 3200 Video
x = 4 = Matrix 6400 Sync
x = 5 = Matrix 3200 Sync
x = 6 = Matrix 6400 Audio
io = Inputs/Outputs (Matrix size). The i and the o
are replaced by two characters which identify the
exact size of the Matrix.
f = Front Panel Controller (FPC-1000)
f = 0 = No, f = 1 = Yes
r = Redundant Power Supply
r = 0 = No, r = 1 = Yes
An example of a typical Matrix 3200/6400 part number follows:
60-250-HD11
For this example: x = 0 = Matrix 6400 Wideband
io = HD = 64x32 which was obtained from the Matrix 6400
Wideband Part Number Table on Page A-2.
f = 1 = yes = Front Panel Controller
r = 1 = yes = Redundant Power Supply
For the example above, the io characters would be HD for matrix size 64x32, DD
for matrix size 32x32 and PH for matrix size 64x64.
The Matrix 3200 Wideband and Matrix 6400 Audio io characters are selected
using the same procedure as is used with the Matrix 6400 Wideband, but with
different tables as shown on Pages A-2 and A-3.
The io characters for the Matrix 3200 Sync part number are DD as it is only
available in one matrix size, 32x32. The io characters for the Matrix 6400 Sync
part numbers are PH as it is also available in only one matrix size, 64x64. Either
of the two Sync part numbers may include r = 0 or 1 but f must be 0 as a Sync
module cannot have a Front Panel Controller.
Matrix 3200/6400 Part Numbers (with matrix tables) are shown on Pages A-2
and A-3.
A-1