Filter
Top Products
3-9
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation
PRELIMINARY
Example 2: Add a video tie to a set of video and audio ties
In the following example, a new video tie is added to the current configuration.
The example shows the front panel indications that result from your actions.
N
This example assumes that you have performed example 1.
1. Select video only for the tie (figure 3-8).
I/O
AUD
VID
Press the button to cycle
through the selections.
The video LED lights when video is selected.
The audio LED is off when audio is deselected.
Figure 3-8 — Select video only
2. Press and release the Input 5 button (figure 3-9).
2
6
5
4
INPUTS
OUTPUTS
1
8
6
5
4
3
7
Press and release the Input 5 button.
The Input 5 LED lights to
indicate that input 5 is selected.
The Output 3, Output 4, and Output 8 LEDs light to indicate the ties created in
example 1.
Figure 3-9 — Select an input
3. Press and release the Output 1 button (figure 3-10).
7
6
5
2 4
1
8
3
OUTPUTS
Press and release the Output 1 button.
The Output 1 LED blinks to indicate that the selected input will be tied to this output.
= Blinking LED
Figure 3-10 — Select the output
4. Press and release the Enter button (figure 3-11).
ENTER
3 4
8
15
INPUTS
OUTPUTS
The LEDs for the selected input, the selected outputs,
and the tied outputs light steadily for approximately 1
second to indicate the tie and then go out.
Press the Enter button to
confirm the configuration
change.
1 second
Figure 3-11 — Press the Enter button