Filter
Top Products
FS-8700-64 ATMI ACM Page 16 of 22
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
ATMI:#3 Error. Incoming data on port=%d is being abandoned. MapDesc rqd.
No map descriptors were found on the indicated port with which the driver could store the
incoming data. Change the CSV file and reset the FieldServer. This message is only printed
once even if the error occurs more than once.
ATMI:#6 FYI. The mapDesc called <%s> is too short.
Edit the CSV file. Increase the length of the map desc and reset the FieldServer.
ATMI:#5 FYI. You could have used a mapDesc called <%s> to expose diagnostic info.
No action I s required. Read section 6.3 for more information..
*ATMI:#9 Err. Mapdesc=<%s> data array=<%s> too short
The data array associated with the map descriptor being used to store ‘current port‘ data is too
short. Increase the length of the data array (not the length of the map descriptor) to at least 17.
For malfunction map descriptors set the length to at least 100. Edit the CSV file, make the
change and then reset the bridge.
*ATMI:#10 Err. Mapdesc=<%s> data array=<%s> too short
The data array defined by the DA_Bit_Name parameter associated with the map descriptor
being used to store ‘current port‘ data is too short. Increase the length of the data array (not the
length of the map descriptor) to at least 90. Edit the CSV file, make the change and then reset
the bridge.
*ATMI:#11 Err. Mapdesc=<%s> data array=<%s> too short
The data array defined by the DA_Byte_Name parameter associated with the map descriptor
being used to store ‘current port‘ data is too short. Increase the length of the data array (not the
length of the map descriptor) to at least 90. Edit the CSV file, make the change and then reset
the bridge.
2Mapdesc=<%s> Gas#=%d. Too big.The driver is trying to store the the current port’s gas data.
A Gas number larger than 16 has been found. It cannot be stored and has been discarded.
Your ACM may need re-configuring. Changing the driver configuration will not correct this
problem. Report this error to ATMI.*These messages are produce once only and then
suppressed so that they do not fill the error log every by being re-printed every time a new
message is processed. A consequence of this, is that, if the error occurs more than once in a
configuration, the second and subsequent occurrences will not be revealed until the first has
been corrected.
*ATMI:#13 Error. Illegal Map Descriptor length - defaulting to 1