Filter
Top Products
51
Setting
On start
When this function is “On”, the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
✔
Note:
Be sure to turn the projector off properly (see “Turning Off the
Projector” on page 22). If the projector is turned off in the incorrect
sequence, the On start function does not operate properly.
Lamp control
Remote control
This function allows you to change brightness of the
screen.
Normal ....normal brightness
Auto ........brightness according with the input signal
Eco ..........lower brightness reduces the lamp
power consumption and extends the
lamp life.
On start
Remote control
Setting
Pointer
You can emphasize a part of the projected image with this
function. Choose either Spotlight or Pointer with the Point
ed button and press the SELECT button. Then select one
of three different sizes (Large, Middle, and Small) of
Spotlight or a pointer of three different patterns (Arrow,
Finger, and Dot) of Pointer. (See page 13 for operation.)
This projector provides eight different remote control codes
(Code 1-Code 8); the factory-set, initial code (Code 1) and
the other seven codes (Code 2 to Code 8). This switching
function prevents remote control interference when
operating several equipment at the same time.
The same code should set on both the projector and the
remote control. For example, operating the projector in
“Code 7”,the remote control unit also must be switched to
“Code 7”.
To change the code for the projector;
Select a remote control code in this Setting Menu.
To change the code for the remote control;
While holding down the MENU button, press the IMAGE
button number of times corresponding to the remote
control code for the projector. (See page 14 for details.)