Filter
Top Products
Getting started Factory default FortiGate configuration settings
FortiGate-60 Installation Guide 01-28008-0018-20050128 21
Factory default Transparent mode network configuration
In Transparent mode, the FortiGate unit has the default network configuration listed in
Table 4 .
Factory default firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. The factory default configuration contains one firewall policy that allows
all traffic originating on the internal network to access the Internet. No other traffic is
allowed through the FortiGate unit. To allow traffic through the FortiGate unit you can
add firewall policies. See the FortiGate Administration Guide for information about
adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Network Settings
Default Gateway (for default route) 192.168.100.1
Interface connected to external network
(for default route)
wan1
Default Route
A default route consists of a default gateway and the name of
the interface connected to the external network (usually the
Internet). The default gateway directs all non-local traffic to this
interface and to the external network.
Primary DNS Server 207.192.200.1
Secondary DNS Server 207.192.200.129
Table 3: Factory default NAT/Route mode network configuration (Continued)
Table 4: Factory default Transparent mode network configuration
Administrator
account
User name: admin
Password: (none)
Management IP
IP: 10.10.10.1
Netmask: 255.255.255.0
DNS
Primary DNS Server: 207.194.200.1
Secondary DNS Server: 207.194.200.129
Administrative access
Internal HTTPS, Ping
WAN1 Ping
WAN2 Ping
DMZ HTTPS, Ping