Fortinet 60c Computer Hardware User Manual


 
FortiGate-60 Installation Guide Version 2.80 MR8
FortiGate-60 Installation Guide 01-28008-0018-20050128 39
Transparent mode installation
This chapter describes how to install a FortiGate unit in Transparent mode. If you want
to install the FortiGate unit in NAT/Route mode, see “NAT/Route mode installation” on
page 27. If you want to install two or more FortiGate units in HA mode, see “High
availability installation” on page 47. For more information about installing the FortiGate
unit in Transparent mode, see “Planning the FortiGate configuration” on page 23.
This chapter describes:
Preparing to configure Transparent mode
Using the web-based manager
Using the command line interface
Using the setup wizard
Connecting the FortiGate unit to your network
Next steps
Preparing to configure Transparent mode
Use Table 9 to gather the information that you need to customize Transparent mode
settings.
You can configure Transparent mode using four methods:
the web-based manager GUI
front control buttons and LCD
command line interface (CLI)
setup wizard
The method you choose depends on the complexity of the configuration, access and
equipment, and the type of interface you are most comfortable using.