Fortinet FortiGate-5000 Network Card User Manual


 
FortiGate-5000 Series Introduction
42 01-30000-83466-20090108
Front panel LEDs and connectors FortiGate-5005FA2 security system
2 USB connectors.
Mounting hardware.
LED status indicators.
The FortiGate-5005FA2 board comes supplied with fiber and copper SFP
transceivers. You can order the SFP transceivers in any combination. Before you
can connect any FortiGate-5005FA2 front panel interfaces, you must insert the
SFP transceivers into the FortiGate-5005FA2 front panel cage slots.
Front panel LEDs and connectors
From the FortiGate-5005FA2 font panel you can view the status of the front panel
LEDs to verify that the board is functioning normally. You also connect the
FortiGate-5005FA2 board to your network through the front panel ethernet
connectors. The front panel also includes the RJ-45 console port for connecting to
the FortiOS CLI and two USB ports. The USB ports can be used with a Fortinet
USB key. For information about using the FortiUSB key, see the FortiGate-5000
Series Firmware and FortiUSB Guide.
LEDs
Table 10 lists and describes the FortiGate-5005FA2 board LEDs.
Table 10: FortiGate-5005FA2 board LEDs
LED State Description
Fabric ACT 2 Amber Network activity at backplane fabric interface 2.
LINK 2 Green Backplane fabric interface 2 is connected at 1000 Mbps.
ACT 1 Amber Network activity at backplane fabric interface 1.
LINK 1 Green Backplane fabric interface 1 is connected at 1000 Mbps.
Base ACT 2 Amber Network activity at backplane base interface 2 (backplane2).
LINK 2 Green Backplane base interface 2 (backplane2) is connected at
1000 Mbps.
ACT 1 Amber Network activity at backplane base interface 1 (backplane1).
LINK 1 Green Backplane base interface 1 (backplane1) is connected at
1000 Mbps.
OOS
(Out of
Service)
Off Normal operation.
Red A fault condition exists and the FortiGate-5005FA2 blade is
out of service (OOS). This LED may also flash very briefly
during normal startup.
ACC Off or
Flashing
green
The ACC LED flashes green when the FortiGate-5005FA2
board accesses the FortiOS flash disk. The FortiOS flash
disk stores the current FortiOS firmware build and
configuration files. The system accesses the flash disk when
starting up, during a firmware upgrade, or when an
administrator is using the CLI or GUI to change the FortiOS
configuration. Under normal operating conditions this LED
flashes occasionally, but is mostly off.
STATUS Amber The FortiGate-5005FA2 board is powered on.