Filter
Top Products
White Paper Issue: October 2006 Integration of BX600 SB9 Switches in Cisco Networks Page 25 / 47
2.5.3 Configuration
The following sample configurations show how to set up the switches’ access ports and the NIC drivers in a typical setup as
shown in Figure 11.
Figure 11 : Typical access port configuration
The following steps are required to configure this scenario:
• Step 1: Configure the access ports of the switches
• Step 2: Configure the Broadcom Adapter
• Step 3: Configure the Inter Adapter
Step 1: Configure the access ports of the switches
! Configuration of bx6-sb9-a
interface 0/1
! This line is only needed if you are running STP on the switch
spanning-tree edgeport
! Forbid all VLANs but the access VLAN
switchport forbidden vlan add 1
switchport forbidden vlan add 20
! Permit the access VLAN
switchport allowed vlan add 10
! Set the access VLAN as native VLAN
switchport native vlan 10
exit
interface 0/2
! This line is only needed if you are running STP on the switch
spanning-tree edgeport
! Forbid all VLANs but the access VLAN
switchport forbidden vlan add 1
switchport forbidden vlan add 10
! Permit the access VLAN
switchport allowed vlan add 20
! Set the access VLAN as native VLAN
switchport native vlan 20
exit
! Configuration of bx6-sb9-b
interface 0/1
! This line is only needed if you are running STP on the switch
spanning-tree edgeport
! Forbid all VLANs but the access VLAN
switchport forbidden vlan add 1
switchport forbidden vlan add 20
! Permit the access VLAN