Filter
Top Products
White Paper Issue: October 2006 Integration of BX600 SB9 Switches in Cisco Networks Page 47 / 47
Delivery subject to availability, specifications subject to change without notice, correction of errors
and omissions excepted.
All conditions quoted (TCs) are recommended cost prices in EURO excl. VAT (unless stated
otherwise in the text). All hardware and software names used are brand names and/or trademarks
of their respective holders.
Copyright Fujitsu Siemens Computers, 10/2006
Published by:
FSC EP ESB ST PRIMERGY
Enterprise Server Business, Support &
Trainings
Extranet:
http://extranet.fujitsu-siemens.com/primergy
Internet:
http://www.fujitsu-siemens.com/primergy
0/11 Enable
0/12 Enable
0/13 Enable
0/14 Enable
0/15 Enable
0/16 Enable
4.6 Port Monitoring
4.6.1 Introduction
When a network analyzer is used in a switched network, a special switch port configuration is needed in order to copy frames
from a specified port to the analyzer port.
This feature is called the “port-monitor” at the SB9 or the “port-mirror” for Cisco switches. The SB9 supports one monitor
session with multiple source interfaces, and one destination interface to which the network analyzer is connected. At present
port-mirror is not supported on port-channel interfaces.
4.6.2 Configuration of Port Monitoring
The following steps are necessary in order to configure a port monitor session.
• Step 1: Configure the SB9
• Step 2: Check the configuration
Step 1: Configure the SB9
! Stop an existing monitor session if applicable
no port-monitor session 1
! Start a new monitor session
port-monitor session 1 source interface 0/1
port-monitor session 1 destination interface 0/4
port-monitor session 1 mode both
Step 2: Check the configuration
(bx6-sb9-a) #show port-monitor session 1
Session ID Admin Mode Dest. Port Source Port
---------- ---------- ---------- -------------
1 Enable-Both 0/4 0/1
4.7 Further information in the Internet:
PRIMERGY servers
www.fujitsu-siemens.com/primergy