Fujitsu C141-E252-01EN Computer Drive User Manual


 
C141-E252 55
CHAPTER 5 Installation
5.1 Notes on Handling HDDs
5.2 Setting
5.3 Mounting HDDs
5.4 Checking Operation after Installation and Preparing
the HDDs for Use
5.5 Dismounting HDDs
This chapter describes the notes on handling HDDs, setting, mounting HDDs, confirming HDD operations
after installation and preparation for use, and dismounting HDDs.
5.1 Notes on Handling HDDs
The items listed in the specifications in Table 2.3 must be strictly observed.
(1) General notes
a) Do not give the HDD shocks or vibrations exceeding the value defined in the specifications
because it may cause critical damage to the HDD. Especially be careful when unpacking.
b) Do not leave the HDD in a dirty or contaminated environment.
c) Since static discharge may destroy the CMOS semiconductors in the HDD, note the following
after unpacking:
Use an antistatic mat and body grounding when handling the HDD.
Hold the DE when handling the HDD. Do not touch PCAs except for setting.
High temperature
To prevent injury, never touch the HDD while it is hot. The DE and
LSI become hot during operation and remain hot immediately after
turning off the power.