Filter
Top Products
fi-5000N Getting Started 15
2. If the capturing of your fingerprint is successfully
done, a buzzer sounds and at the same time the
following screen appears. Remove your finger
from the fingerprint sensor.
3. Next, the identification of your fingerprint begins.
If the identification of your finger is successfully
done, a buzzer sounds and the following screen
appears.
Load the document on to ADF and press [Scan] or
[Send to] button on the scanner.
Authentication by PIN
1. At the logout status, open the cover and press
the [ID] key.
The "Select User" screen appears as follows.
2. Select the registered user with the [K], [L] keys,
and press the [ENT] key.
The next screen appears, and the PIN is prompted.
3. Enter the user’s PIN, and press the [ENT] key.
If the PIN does not match, the message "The PIN is
incorrect" appears. and you are prompted to enter
again.
4. If the PIN matches, a buzzer sounds and the fol-
lowing screen appears.
■ Starting the Scanning Operation
Load a document on the scanner connected to fi-5000N,
and press the [Scan] button (or the [Send to] button
depending on fi-5000N Software [Launch] option set-
ting) on the scanner.
Scanning starts, and the document is ejected.
The operation is successfully done if the ScandAll 21
software (installed on the image data receiving com-
puter) starts and the scanned image appears on the
monitor screen.
HINT
You can also select the registered
user by entering user ID number:
1. With the keyboard, enter the user
ID number.
2. Press the [ENT] key.
⇒ The name of the user to log in will
appear selected.
3. Press the [ENT] key again.
Identifying...
Remove your finger
from the sensor
(user's name)
Load the documents
onto scanner & press
[Scan]/[Send to]
Select User
1(user's name)
2(user's name)
3(user's name)
PIN:_
Cancel:[ESC]
(user's name)
Load the documents
onto scanner & press
[Scan]/[Send to]