Fujitsu fi-5000N Network Card User Manual


 
ii
INTRODUCTION
Thank you for purchasing the fi-5000N.
This document describes the installation and basic oper-
ation methods of the fi-5000N. Before using, be sure to
thoroughly read this manual to ensure correct operation.
The "Operator’s Guide" is stored on the Setup Disk.
The guide provides useful and detailed information on
operations when you would like to use advanced fea-
tures, and troubleshooting. Please also read the Opera-
tor’s Guide for your reference.
Regulatory Information
FCC declaration
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
located.
Consult your dealer or an experienced radio/TV
technician.
FCC warning: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
Canadian DOC Regulations
This digital apparatus does not exceed the Class B
limit for radio noise emissions from digital
apparatus set out in the Radio interference
Regulations of the Canadian Department of
Communications.
This Class B digital apparatus complies with
Canadian ICES-003.
Le présent appareil numérique n'émet pas de
parasites radioélectriques dépassant les limites
applicables aux appareils numériques de la classe
B, limites prescrites dans le Règlement pour le
brouillage radioélectrique qui fut dicté par le
Ministère des Communications du Canada. Cet
appareil numérique de la classe B est conforme à
la norme NMB-003 du Canada.
Bescheimigung des Herstellers /
Importeurs
Für den fi-5000N wird folgendes bescheinigt:
In Übereinsstimmung mit den Bestimmungen
der EN45014(CE) funkentstört
Maschinenlärminformationsverordnung 3.
GPSGV: Der höchste Schalldruckpegel beträgt
70 dB (A) oder weniger, gemäß EN ISO 7779.
ATTENTION
The use of a shielded interface cable
is required to comply with the Class B
limits of Part 15 of FCC rules.
The length of the AC cable must be 2
meters (6.6 feet) or less.