Filter
Top Products
50
<Drawer connection 1>
Notes:
1. Use a shielded drawer cable.
2. Two drives cannot be driven simultaneously.
3. The drawer on/off time must be specified using t1 and t2 in
the pulse generation command (ESC p m t1 t2).
4. The drawer drive duty must be as follows:
ON-time/(ON-time + OFF-time) ≤ 0.2
5. The drawer power must always be supplied from the printer
power supply unit via connector pin 4.
6. The resistance of the drawer kick solenoid must be at least 24 Ω.
If a solenoid with a lower resistance is used, the solenoid might
be destroyed by over current.
APPENDIX
Printer
2
3
4
5
6
Cable Drawer
3
4
5
6
2
Drawer kick solenoid
(24 Ω minimum)
Drawer
open/close
switch
1 1