Filter
Top Products
53
C-1. Test Printing
Turn off the printer power switch, put the paper in place, and turn on
the printer power switch while holding down the FEED switch on the
control panel. The data below is printed. When "Test print" is printed,
press the FEED switch for about two seconds to start the test
printing.
After a fixed amount of data is printed, the paper is automatically cut
and the test printing terminates.
TEST PRINT
ITEM SELECTION: FEED SW IS PUSHED SHORT
ITEM SELECTION: FEED SW IS PUSHED LONG
Example of contents of test printing
Firmware Number KA02001-J005
Firmware Version 01A (018701)
POWER ON STATUS DISABLE
RECEIVE BUFFER 4K BYTE
BUSYCONDITION
OFFLINE/BUFFERFULL
RECEIVE ERROR ?PRINT
AUTO LF DISABLE
•
•
Appendix C: Special Modes
END
SET UP
HEX DUMP
TEST PRINT
SELECTION ITEM