Filter
Top Products
Removing and installing compo nen ts
during servicing
Preparing to remove components
If you are going to remove or change system components, prepare for the remo val as follows:
Please observe the safety information in chapter "Important notes", Page 14.
Remove the power plug from the mains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables
from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► Remove the battery
(see "
Removing a battery", Page 61 ).
Installing and removing memory expansion
MemorymoduleMainmemoryRemovingmemor
y
Systemexpansi
on
Systemexpansi
on
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter "Important notes", Page 14.
When installing/removing mem ory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see "
Preparing to remove components", Page 96 .
Only use memory expansion modules that have been approved for your
notebook (see "
Technical data", P age 113).
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the m emory extension compartment.
You must open the service compartment to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. Therefore, be sure to observe the following:
Individual components can become very hot during operation. Therefore, we
recommend that you wait one h our af ter switching off the notebook before removing
or installing memory modu les. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on installing and removing boards and components", Page 95.
96 Fujitsu Technology Solutions