Fujitsu FPCM11981 Tablet User Manual


 
Manufacturer’s notes
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause interference, and
(2) this de vice must accept any interference, including interference that may
cause undesired operation of this device.
FCC Interference Statement
This equipment has bee n tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits a re designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio freq uency energy. If not installed and used in accordance with
the instructions, it may cause harmful interference to r adio communications.
However, there is no guarantee that interferenc e will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television r ece ption, which
can be determined by turning the equipment off a nd on, the user i s encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4. Consult the dealer or an experienced radio/T V technician for help.
Please note the following regulatory information related to the optional radio device.
FCC Radio Frequency Exposure statement
This radio device has been evaluated under FCC Bulletin OET 65C and found compliant with the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093 , and 15.247 (b) (4) addressing RF
Exposure from radio frequency devices. The radiated output power of this radio device is far below
the FCC radio frequency exposure limits. Nevertheless, this device shall be used in such a manner
that the potential for human contact during normal operation is minimized. When using this device, a
certain separation distance between antenna an d nearby persons must be maintained to ensure RF
exposure compliance. In order to comply with RF e xposure limits established in the A NSI C95.1
standards, the distance between the antennas and the user should not be less than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and authorisation for use
Radio-frequency electromagnetic energy is emitted from the w ireless devices. The energy levels
of these emissions, however, are far much less than the electromagnetic energy emissions from
wireless devices such as mobile phones. Radio devices are safe for use by consu mers because
they operate within the guidelines found in radio frequency safety standards and recommendations.
The use of the radio devices may be restricted in some situations or environments, such as:
on board an airplane, or
in an explosive environment, or
in situations where the interference risk to other devices or services is
perceived or identied as harmful.
In cases in w hich the policy regarding use of radio devices in specic environments is not
clear (e.g., airports, ho spitals, chemical/oil/gas industrial plants, private buildings), obtain
authorization to use these devices prior to operating the equipment.
Regulatory Information/Disclaimers
Fujitsu Technology Solutions 121