Fujitsu FPCR47651 Laptop User Manual


 
58
- Memory Upgrade Module
Memory Upgrade Module
Your LIFEBOOK notebook comes with a minimum of 6 GB (4 GB + 2 GB) of high speed Double Data Rate Synchronous
Dynamic RAM (DDR3-1600 SDRAM factory installed. To increase your notebook’s memory capacity, you may install an
additional or larger memory upgrade modules. The memory upgrade must be a dual-in-line (DIMM) SDRAM module.
To ensure 100% compatibility, purchase the SDRAM module only from the Fujitsu web store at www.shopfujitsu.com.
Installing Memory Upgrade Modules
1 Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2 Turn the notebook bottom side up, and remove the five screws from the large memory upgrade module
compartment (Figure 30). Remove the cover (Figure 31).
3 Remove the new memory upgrade module from the static guarded sleeve.
4 Align the memory upgrade module with component side up (Figure 32). Align the connector edge of the upgrade
module with the connector slot in the compartment. Be sure the alignment keys line up with those in the slot.
DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES SPECIFICALLY SHOWN IN THE DIRECTIONS
FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE.
THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE (ESD). TO MINIMIZE RISK TO THE MODULE, OBSERVE
THE FOLLOWING PRECAUTIONS:
BEFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC ELECTRICITY BUILT UP IN YOUR BODY.
WHEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY CONTACTS OR CHIPS. BE CAREFUL NOT
TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS; THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS.
BE SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES. EVEN IF THE SYSTEM IS IN HIBERNATE OR STANDBY
STATES, DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM.
THE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR NOTEBOOK. ONCE IT IS INSTALLED, YOU SHOULD LEAVE IT
IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM MEMORY CAPACITY.