Filter
Top Products
Installation
4-2 C156-E228-02EN
b) Use care to avoid exerting excessive pressure on the unit when removing the
cushions.
c) Use care to avoid exerting excessive pressure on the PCA surface and
interface connectors when removing the drive from the antistatic bag.
d) If the temperature difference between installation locations is 10 degrees or
more, leave the drive in the new location for at least two hours before
unpackaging it.
(3) Installation
a) Do not connect or disconnect the connectors or change the terminal settings
when the power is on.
b) Do not move the drive with the power on.
c) Eject the optical disk cartridge, lock the carriage securing the head, turn off
the power, then move the drive.
Before moving the drive, remove the optical disk cartridge. If the
drive is moved with the optical disk cartridge loaded in it, the head
may move back and forth in the drive to damage the head or disk
and reading the data may fail.
(4) Packaging
a) Before packaging, remove the optical cartridge.
b) Store the drive in an antistatic plastic bag with desiccant (silica gel).
c) Use the same cushions and packaging supplied with the drive. If they are not
available, ensure that adequate shock absorbent material is used. In this case,
some method of protecting the PCA surface and interface connectors must be
used.
d) Ap "UP" and "Handle With Care" labels to the outside of the package.
Figure 4.1 shows the individual packaging style and Figure 4.2 shows the gathered
packaging style. (The form and material of the cushion may be changed.)