Filter
Top Products
13
Connecting the PCs
(1) Speaker
(2)
(4)
(3) (5)
(6)
(6)
1. Start by turning the PCs off.
2.
1) Connect the KB/Mouse connector of the
1st host to the KB/Mouse connector on the
switch device. Be sure to connect the host
side first, then the switch device. (Connect
(2).)
This connection is not required when the
switch device is to be used only on the
USB port.
2) Connect the USB connector on the host to
the USB connector on the switch device
using the special cable. Be sure to connect
the host side first, then the switch
device.(Connect (3).)
This connection is not required when the
USB port is not used.
When both (2) and (3) are connected, the
USB port and USB Bridge function are
used for HUB functions, and keyboard and
mouse data is sent from the KB/Mouse
connector (PS/2).
3) Connect the monitor connector on the host
to the monitor connector on the switch
device using the special monitor cable. Be
sure to connect the host side first, then the
switch device. (Connect (4).)
4) Connect the Line Out jack on the host to
one of the Audio Connector IN jacks on the
switch device using an audio cable.
(Never connect the PC’s Speaker Out jack,
as this can cause damage.)
5) Connect the 2nd host in the same way.
6) Next, connect the special AC adapter
when the switch device is connected to the
USB port. (Connect (5).)
7) Next, connect the console
(keyboard/mouse/monitor/speaker).
(Connect (6).)
■ NOTE ■
Use a 3-wire power code cable, and connect the
earth cable to the terminal.
When you use a 2-wire type adapter, be sure to
ground the earth wire.