Filter
Top Products
E-30
ADJUSTING TO A DESIRED PICTURE (PICTURE MENU) (Continued)
• Jaggies Filter
This function alleviates the phenomenon where jagged
diagonal lines can be seen when interlace signals are input,
thus enabling a smoother motion picture display.
Each time
c or d is pressed, the setting is switched.
<
Auto
<
Off
<
Press
Z to store.
• Motion Setting
The detecting sensitivity for motion picture is set.
The response of the picture processing is valued in the motion
picture priority setting.
Press
d: to specify still picture priority.
Press
c: to specify motion picture priority.
Press
Z to store.
You can create your favourite image by fine tuning the
brightness.
• High Point
In a bright image scene, sets the point where the brightness is
to be adjusted.
Press
c or d to set the point where the brightness is to be
adjusted.
Press
Z to store.
• High Point Gain
Fine tunes the brightness of the point set by High Point.
Press
c to be darker.
Press
d to be brighter.
Press
Z to store.
• Low Point
In a dark image scene, sets the point where the brightness is to
be adjusted.
Press c or d to set the point where the brightness is to be
adjusted.
Press
Z to store.
• Low Point Gain
Fine tunes the brightness of the point set by Low Point.
Press
c to be darker.
Press
d to be brighter.
Press
Z to store.
• This function allows setting of the screen to your favourite
luminance matched to the ambient brightness.
• The ALC Setting function operates when the ambient sensor
is turned on. (See “Ambient Sensor” on P. E-27.)
• High Point Level
Sets the upper limit value of the ambient brightness detected by
the ambient sensor.
Press
c to lower the upper limit value.
Press
d to raise the upper limit value.
Press
Z to store.
• High Point Gain
Sets the upper limit value of the screen luminance
corresponding to the brightness detected by the ambient sensor
in a bright environment.
Press
c to lower the upper limit value.
Press
d to raise the upper limit value.
Press
Z to store.
• High Point Limit
Limits control of the screen luminance corresponding to the
ambient sensor when the value detected by the ambient sensor
exceeds the High Point Level and High Point Gain.
Each time
c or d is pressed, the setting is switched.
[On]: Limit operates
[Off]: Limit does not operate
Press
Z to store.
• Low Point Level
Sets the lower limit value of the ambient brightness detected by
the ambient sensor.
Press
c to lower the lower limit value.
Press
d to raise the lower limit value.
Press
Z to store.
• Low Point Gain
Sets the lower limit value of the screen luminance
corresponding to the brightness detected by the ambient sensor
in a dark environment.
Press
c to lower the lower limit value.
Press
d to raise the lower limit value.
Press
Z to store.
• Low Point Limit
Limits control of the screen luminance corresponding to the
ambient sensor when the value detected by the ambient sensor
is lower than the Low Point Level and Low Point Gain.
Each time
c or d is pressed, the setting is switched.
[On]: Limit operates
[Off]: Limit does not operate
Press
Z to store.
Note
• There are the following conditions at the settable value:
High Point Level > Low Point Level
High Point Gain > Low Point Gain
Gamma
ALC Setting
7701_01_E.book 30 ページ ２００７年３月２２日 木曜日 午後２時３８分