Fujitsu P8010 Laptop User Manual


 
66
- Memory Upgrade Module
Memory Upgrade Module
Your LifeBook notebook can be upgraded to include up to 4 GB of in-slot high speed Double Data Rate
(DDR2) Synchronous Dynamic RAM (SDRAM). To increase your LifeBook notebook’s memory
capacity, you may install a larger memory upgrade module.
Your LifeBook notebook has two micro DIMM slots. If you have less than 4 GB pre-installed, and you would
like to increase it, you will need add a new module to the empty slot. The memory upgrade must be a dual-
in-line (micro DIMM) SDRAM module. To ensure 100% compatibility, purchase the memory module only
from the Fujitsu web store at us.fujitsu.com/computers.
Accessing the Memory Compartment
To gain access to the memory compartment, follow these steps:
DO NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE ONES
SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY UPGRADE MODULE.
THE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE (ESD). TO
MINIMIZE RISK TO THE MODULE, OBSERVE THE FOLLOWING PRECAUTIONS:
BEFORE HANDLING A MEMORY MODULE, TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC
ELECTRICITY BUILT UP IN YOUR BODY.
WHEN INSTALLING OR REMOVING A MEMORY MODULE, HOLD IT BY THE EDGE SO AS NOT TO TOUCH ANY
CONTACTS OR CHIPS. BE CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR COMPONENTS;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS.
BE SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES. EVEN IF THE
SYSTEM IS IN HIBERNATE OR STANDBY STATES, DATA COULD BE LOST OR THE MEMORY COULD BE DAMAGED
IF POWER IS STILL AVAILABLE TO THE SYSTEM.
YOU MUST TURN OFF POWER AND REMOVE ANY MODEM CONNECTION BEFORE INSTALLING THE
MEMORY UPGRADE MODULE.