Filter
Top Products
PRN608-S
28-03-2003 Page 3-27 of 53
3.8.29 Stop sending automatic status
[Name] Stop sending automatic status
[Format] ASCII ESC b
Hex 1B 62
Decimal 27 98
[Description] When this command is sent then it will turn
off transmitting status.
3.8.30 Color/Grey scale graphic
[Name] Colour / Grey scale graphic
[Format] ASCII ESC c n
Hex 1B 63 n
Decimal 27 99 n
[Description] When this command is sent then will the
board not feed. After the next graphic data
(both compression and not). The n is a
percent of the burn ratio, n can be from 0 to
15, and the burn ratio is 100/15*n. This
command is used by the driver to make
colour and grey scales printout.
3.8.31 Enable saving data
[Name] Enable saving data
[Format] ASCII ESC d
Hex 1B 64
Decimal 27 100
[Description] This command will enable that the boards
save values to the flash, this is made to
ensure that a wrong transmission not will
change settings in the board, remember to
send the command “Saving data to board”,
to actual save the data.
3.8.32 Save data to board
[Name] Save data to board
[Format] ASCII ESC e
Hex 1B 65
Decimal 27 101
[Description] This command saves all settings to flash.