Filter
Top Products
PRN608-S
28-03-2003 Page 3-33 of 53
PAPER OFFSET (default 2mm) This value is the length
between Black Mark and start of printing. Value must
be between 2 mm. and Page length – 2mm.
BLACKMARK LENGTH (default 15mm). This is the
length of the Black Marks.
The board can be set to transmit a ’B’ whenever the
paper is not detected at paper detect. This is typical
when the sensor encounters a Black Mark.
The following commands is used for enabling Black
Mark
Default:
PAGELENGHT=150mm
PAPEROFFSET=2mm
BLACKMARK=120 (120/8=15mm)
ESC+205+1+98+n
n: Bit 0: if set the board will transmit ’B’ every time
paper is not detected at the paper detector.
Bit 1: if set the Black Mark function is enable.
Default n = 0.
3.8.43 Graphic data – non compressed
[Name] Graphic data – non-compressed
[Format] ASCII US d1,d2,..,dX
Hex 1F d1,d2,..,dX
Decimal 31 d1,d2,..,dX
[Range] n: [0;255]
X=54 for FTP628MCLxxx, X=72 for FTP638MCLxxx,
[Description] When the printer controller receives this command the
X graphic bytes (d1-dX) will be printed in one dot line.
The MSB in d1 is the left most dot and the LSB in dX is
the right most dot.
3.8.44 Graphic data – compressed
[Name] Graphic data – compressed
[Format] ASCII Y d1,d2,..,d(-Y)
Hex Y d1,d2,..,d(-Y)
Decimal Y d1,d2,..,d(-Y)
[Range] Y: [-X;-2]
n: [0;255]
X=54 for FTP628MCLxxx, X=72 for FTP638MCLxxx,