Filter
Top Products
PRN608-S
28-03-2003 Page 1-5 of 53
3.8.18 Italic off..........................................................................................................3-24
3.8.19 Italic on..........................................................................................................3-24
3.8.20 Initialise Printer.............................................................................................3-24
3.8.21 Request Software version...............................................................................3-25
3.8.22 Request Status................................................................................................3-25
3.8.23 Request Analog voltage..................................................................................3-25
3.8.24 Request Temperature .....................................................................................3-25
3.8.25 Sub command set............................................................................................3-26
3.8.26 Upgrade command.........................................................................................3-26
3.8.27 Set auxiliary output........................................................................................3-26
3.8.28 Automatic sending status................................................................................3-26
3.8.29 Stop sending automatic status........................................................................3-27
3.8.30 Color/Grey scale graphic...............................................................................3-27
3.8.31 Enable saving data.........................................................................................3-27
3.8.32 Save data to board .........................................................................................3-27
3.8.33 Change dot size..............................................................................................3-28
3.8.34 Change form feed length................................................................................3-28
3.8.35 Change baud rate...........................................................................................3-28
3.8.36 Change form feed time...................................................................................3-28
3.8.37 Feed Paper.....................................................................................................3-29
3.8.38 Compensate Burn time...................................................................................3-29
3.8.39 Bar code width setting....................................................................................3-29
3.8.40 Bar code height setting...................................................................................3-30
3.8.41 Bar code printing...........................................................................................3-30
3.8.42 Black Mark.....................................................................................................3-32
3.8.43 Graphic data – non compressed ....................................................................3-33
3.8.44 Graphic data – compressed ...........................................................................3-33
3.8.45 Escape sequences, overview...........................................................................3-34
4 MAINTENANCE.........................................................................................................4-36
4.1 DAILY USE..............................................................................................................4-36
4.2 STORE/TRANSPORT.................................................................................................4-36
5 SPECIFICATIONS......................................................................................................5-37
5.1 ELECTRICAL DATA .................................................................................................5-37
5.2 MECHANICAL DATA ...............................................................................................5-37
5.3 ENVIRONMENTAL DATA .........................................................................................5-37
5.4 EMC & ESC ..........................................................................................................5-37
5.5 TEMPERATURE TEST...............................................................................................5-38
6 CONNECTOR PIN ASSIGNMENT..........................................................................6-39
6.1.1 Thermal Head connector................................................................................6-39
6.1.2 Thermal Head connector................................................................................6-39
6.1.3 IRDA connector..............................................................................................6-40
6.1.4 Cutter connector ............................................................................................6-40
6.1.5 AUX INPUT connector ..................................................................................6-40
6.1.6 Power connector............................................................................................6-41
6.1.7 USB connector ...............................................................................................6-41
6.1.8 AUX connector...............................................................................................6-42
6.1.9 Serial connector.............................................................................................6-42
6.2 MECHANICAL DRAWINGS.......................................................................................6-43
7 APPENDIX...................................................................................................................7-44
7.1 SEIKO COMPATIBLE COMMAND SET (OPTIONAL).....................................................7-44
7.1.1 Escape sequences, overview...........................................................................7-44
7.2 FUJITSU COMPATIBLE COMMAND SET (OPTIONAL)..................................................7-45