Filter
Top Products
PRN608-S
28-03-2003 Page 6-41 of 53
The paper near end status, can be seen on the LED on the aux
connector, it can be reading through the status command, and if a
driver is used, then it can be reading in the port monitor: If paper jam is
used, then will the printer stop printing if this signal is going low, the
value of this bit can be seen on the LED on the aux output connector, it
can be reading by a status request, or if a driver is used, then it can be
reading by the port monitor
The paper near end and paper jam is indicated on LED at the AUX
connector CN4. The status of these bits can also be read with a
response on a status request. If a driver is used, then the status can
also be read in the print monitor. If paper jam sensor is activated
printing will stop until paper jam sensor is deactivated. The LED will
show these conditions.
The LED will show these conditions
LED Error
Off No Error
Flash 1Hz Paper near end
Flash 2Hz Paper jam
On Both paper jam and near end
6.1.6 Power connector
Power connector CN7: 43045-0400
Mating connector
TBA
Pin Function Pin Function
1 GND 3 GND
2 +8.5V 4 +8.5V
6.1.7 USB connector
USB connector CN5: UBBR-04SW11
Mating connector: