Filter
Top Products
112 Operating Manual RX600 S6
CSS components
● If a memory module is installed and you pull the lever strongly
outwards, the memory module pops up. Doing so may cause a device
failure.
● Please observe the safety information in chapter "Important
information" on page 27.
I To guarantee that all memory modules in the relevant storage mode have
identical characteristics, you must always replace 4 memory modules
on each memory board. The only exception is memory boards running
in spare mode or in independent mode - these only require 2 memory
modules to be replaced.For more information on the individual storage
modes, see the "System Board D3141 for PRIMERGY RX600 S6
Technical Manual".
Figure 30: Removing a memory module
Ê Press the holders on either side of the memory slot concerned outward (1).
Ê Pull the defective memory module out of the slot (2).
/
/
0