Filter
Top Products
116 Operating Manual RX600 S6
CSS components
8.2 Non-hot-plug components
V CAUTION!
● The actions described in this section may only be performed by
personnel with the appropriate technical training. (The device can be
seriously damaged if it is opened without authorization or if repairs
are attempted by untrained personnel.)
● The circuit boards and soldered parts of internal options are exposed
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
● Do not touch the circuitry on boards and soldered parts. Hold the
metallic areas or the edge of the circuit boards.
● Touch only the specified part of the printed circuit board. Failure to do
so may cause injury. It may also cause failures.
● Please observe the safety information in chapter "Important
information" on page 27.
If a defective non-hot-plug component is detected (for more information,
see chapter "Starting up and operation" on page 57 and the "ServerView
Suite Local Service Concept - LSC" manual on the ServerView Suite
DVD 2), proceed as follows:
Ê Exit all applications and shut down the server properly (see section
"Switching the server on and off" on page 69).
Ê Pull all power connectors out of the power outlets.
Ê Remove the server from the rack (see section "Rack
installation/removal of server" on page 43) and place the server on a
table, for example.