Filter
Top Products
29
Configuring the BIOS
www.gateway.com
5 Specify which devices you want to boot from, and in which order.
■ To specify your 3.5-inch, 1.44 MB diskette drive, select Floppy.
■ To specify the Zip drive, select Floptical if your computer is running
AMI BIOS, or select
Iomega Zip if your computer is running Phoenix
BIOS.
6 If your BIOS contains the option Removable Devices, set the boot order for
your multiple drives, then press E
SC.
7 If you removed the 3.5-inch diskette drive and did not replace it, go to
the next step. Otherwise, go to Step 10.
8 Press the right arrow key to display the Advanced menu, then press ENTER
to open the
Peripheral Configuration menu.
9 Set Floppy Disk Controller to Disabled, then press ESC.
10 Press the F10 key, then press ENTER.
■ If you installed a diskette, CD, or DVD drive, the installation is
complete.
■ If you installed a Zip drive, go to “Installing Zip drive software” on
page 30.
■ If you installed a Seagate tape drive, go to “Installing Seagate tape drive
software” on page 31.