Filter
Top Products
47
Tape drive
www.gateway.com
Your computer does not recognize your new SCSI tape drive or other
SCSI devices:
■ Make sure that you have correctly installed the Seagate Backup Exec
software.
■ Make sure that all cables are attached securely.
■ Check the SCSI ID of each device in the SCSI chain to make sure that no
two devices have the same ID number (the controller is usually ID 7 and
the bootable hard drive is usually ID 0).
■ Make sure that SCSI termination is set correctly for each SCSI device.
Termination should be enabled for SCSI devices at each end of the SCSI
chain. All other SCSI devices must have termination disabled.
■ Make sure that you are using the latest drivers for your SCSI host adapter
and operating system. Contact the manufacturer of your SCSI host adapter
for driver information.