Filter
Top Products
CHAPTER 3: Replacing notebook components
62
Replacing the keyboard
Tools you need to complete this task:
Screws removed during this task:
• 3 black M2.5×6 (keyboard cover)
To replace the keyboard:
1 Complete the steps in “Preparing the notebook” on page 47.
2 Remove the keyboard cover by performing steps 2–6 of the “Replacing the
keyboard cover” procedure on page 58.
3 Lift the back edge of the keyboard slightly, then carefully slide it toward the
LCD panel to release the keyboard retaining tabs from the palm rest.
4 Flip the keyboard over onto the touchpad area to access to the keyboard
cable (a).
Open the keyboard cable connector (b) and disconnect the cable (c).
Caution
The keyboard is connected to the notebook through the keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest.
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe