Filter
Top Products
Operations Manual: Safety
Voyager 3
Voyager 3
2004 General Binding Corporation
Page 1-4
Jog/Slow Speed w/Guard Open
1.3 Emergency stops (E-Stop)
The Voyager 3 is equipped with three E-Stops. One
is located on the feeder next to the feeder pile table
controls, the second is located on the laminator con-
trol panel and the third is located on the top of the
laminator electrical box.
To engage an E-Stop, press the E-Stop in.When any
one of the three E-Stops is engaged, all functions of
the machine are stopped and the main pressure
roller is lowered.
To continue operation, all E-Stops must be in the up
position. To release an E-Stop, pull button out.
The Jog and Reset buttons must be held simultane-
ously to allow the slow speed jogging with the safe-
ty guard open. Speed is monitored by relay for safe-
ty purposes.
1.4 Safety shields
The two safety shields, one covering the main roller
and the second covering the separator section, per-
form the same function as an emergency stop.
Both safety shields have a key switch. Once the key
is removed from the switch, all functions of the
machine are stopped and the main pressure roller is
lowered.
To disengage the main roller safety shield switch,
pull up on the safety shield handle located on the
operator side of the laminator.
W
ARNING: Burn hazard, chrome cylinder
stays hot.
To disengage the separator safety shield switch,
slide the shield back towards the stacker table and
raise.