Filter
Top Products
F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 5 - 16
Operations
Section 5.6 Infeed tables
These tables are part of the Falcon 160 safety
features. It is neccessary to have the two infeed tables
properly positioned before running the laminator.
CAUTION
If not installed properly, you can be injured
or cause damage to the table or laminator.
5.6.1 Removing the table
a) Raise the safety shield.
b) With both hands, grip the front edge of the
infeed table and lift up and then out. Refer to
Figure 5.6.1
Figure 5.6.1 Front edge
Front edge
5.6.2 Replacing the infeed table
a) Ensure that the safety shiled is inthe raised
position.
b) With both hands, grip the front edge of the
infeed table and align the back edge with the
support bolts. Refer to Figure 5.6.2
Figure 5.6.2 Back edge
Front
support bolt
c) Now lower the front edge while ensuring that
the pin aligns with the safety roller switch and
the back support bolt. Refer to Figure 5.6.3
Figure 5.6.3 Safety roller switch
Back
support bolt
Safety
roller switch
CAUTION
If the safety roller switches are not engaged,
the laminator will not operate in
"Panel" mode.