Filter
Top Products
F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 5 - 6
Operations
• Press and hold GO for 3 -4 seconds before
releasing the variable speed footswitch.
• Release the variable speed footswitch.
• Release GO. GO should be solid.
3. In the event that the safety shield must be raised
while the laminator is running, Perform the following
steps;
INFORMATION
If the variable speed footswitch is not
close to the speed of the control panel,
output quality may be affected by the
speed difference.
A) To raise the safety shield
INFORMATION
Please keep in mind that when the safety
shield is raised, speed is controlled through
the variable speed footswitch.
• Press and hold on the variable speed footswitch.
( approximately 1/2 the travel distance of the
variable speed footswitch )
INFORMATION
When a safety shield is raised while pressing
on the variable speed footswitch, the speed
may be faster or slower than the indicated
panel speed.
• Raise the safety shield.
INFORMATION
When the safety shield is raised, the
laminator will only run while the variable
speed footswitch is depressed.
• Adjust for desired speed using the variable
speed footswitch.
INFORMATION
Footswitch speed is not indicated in the
SPEED DISPLAY on the control panel.
B) To lower the safety shield
• Lower the safety shield.
INFORMATION
When the safety shield is lowered, speed
reverts to the panel speed setting.
• Press and hold GO for 3 -4 seconds before
releasing the variable speed footswitch.
• Release the variable speed footswitch.
• Release GO. GO should be solid.