Filter
Top Products
F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 5 - 5
Operations
( 25 ) FORWARD s : When pressed, signals the
laminator to run in a forward motion and FORWARD
s becomes solid.
25
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 26 ) REVERSE t : When pressed, signals the
laminator to run in a reverse motion and REVERSE t
becomes solid.
26
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 27 ) SAFETY : Begins flashing anytime the front or
the rear safety shield is in the raised position. This is an
indication for the operator to be very careful when
operating the laminator in the “Footswitch” mode.
27
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 28 ) Variable Speed Footswitch : The variable
speed footswitch, operates the laminator in
“Footswitch” mode. Within this mode, if the safety
shield is up, speed is determined by the variable speed
footswitch. If the safety shield is down, the speed is
controlled through the control panel.
ATTUNG
WARNING
ADVERTENCIA
28
1. To switch from “Panel” mode ( GO is solid ) to
“Footswitch” mode ( GO is flashing ) with the safety
shields in the down position. Perform the following
steps;
• Press on the variable speed footswitch. GO
begins flashing identifying “Footswitch” mode.
• Once the variable speed footswitch is released,
the rollers will stop.
• To make the rollers turn, simply press on the
variable speed footswitch.
INFORMATION
When the safety shield is in the lowered
position and "Footswitch" mode is
engaged, speed is controlled through
the control panel
2. To switch from “Footswitch” mode ( GO is flashing )
to “Panel” mode ( GO is solid ) with the safety
shields in the down position. Perform the following
steps;
• Press and hold the variable speed footswitch
down.