Filter
Top Products
F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 5 - 9
Operations
INFORMATION
Once RESET has been engaged, power will
be restored, Laminating rollers will reset to
1 in. GAP and the display will return to it's
default settings.
Default mode; TOP TEMP. = 68
o
F ( 20
o
C ),
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
e) Enter the desired operating parameters or
select the job number prior to the emergency
stop situation.
f) You may now resume operating the laminator.
Section 5.3 Set up
Initial set up of the Falcon 160 laminator is
easily attained when instructions are followed exactly. It
is suggested and helpful if you take the time to read this
section thoroughly before attempting to do any of the
steps.A complete understanding of this section will
enable you to follow the procedures descibed in
Section 6.1 Application.
5.3.1 Power
a) Clear the area around the laminating rollers and
pull rollers nip..
b) Make sure the laminator is plugged in.
c) Turn the MAIN POWER to the “ON”
position. Refer to Figure 5.3.1
d) Press RESET. The front control panel will
illuminated. Refer to Figure 5.3.1
Figure 5.3.1 MAIN POWER / RESET
Rear of the laminator
MAIN POWER
RESET
5.3.2 Film loading
a) Raise the rear safety shield if placing a roll of
laminate onto the upper unwind shaft.
b) Lift the clevis pin located in the saddle of the
upper unwind shaft.
c) Swing the unwind shaft out enough to slide the
roll of laminate over the core chucks and onto
the unwind shaft. Refer to Figure 5.3.2
INFORMATION
When sliding a roll of laminate onto the
unwind shaft, it helps if you twist the roll
while sliding.
Figure 5.3.2 Unwind shaft
Core Chucks
Core Support
Clevis Pin
Brake Adjustment Knob